PAGE UNDER REVIEW AND NOT FINAL
ALPA PRODUCT PAGE
Product Image Pending
*

ALPA Lens-Shade HR 138 mm full

__

ALPA Lens-Shade HR 138 mm full

Product Description

ALPA Lens-Shade HR 138 mm full, additive manufacturing, for ALPA ALPAGON 6.8/138 mm

ALPA offers a complete range of 16 types of additively manufactured lens hoodsfor all HR Alpagon and HR Alpar lenses. The subtype "0" identifies the round lens hoods when using the full image circle. Subtype "1" is optimized for sensor sizes up to 40x54 mm without or only a tiny amount of movement (especially with sensors of smaller sizes than 40x54).

Therefore: The round subtype "0" versions allow movement over the lens's entire image circle without vignetting. The rectangular subtype "1" versions offer optimum effect without movement and for sensors up to 40x54 mm. They thus block the collection of stray light in the non-visible area that extends beyond the image circle of the recording format.

Additive Manufacturing

This product is completely or partially manufactured additively. ALPA is a pioneer in additive manufacturing and is cooperating with the ETH Zurich - pd|z Product Development Group Zurich.

ALPA Logo for Additive Manufacturing
ALPA eCommerce
Product Introduction
Product Status
ALPA  PID
Professional Price in CHF
Short Description
500.110.138
free, courtesy of ALPA
258.00
Price on request
Price on request
Product Image Pending
ALPA Lens-Shade HR 138 mm full